Chosen Solution
I’m hoping that some people have come across this before as it’s new to me. I changed out the analogue stick on this joycon and now it won’t charge. Iv done loads of these and it’s the first time I’ve had this. Before I dig into it I wondered if there was a simple answer. Works when connected to the console. Won’t charge when plugged in. All connectors checked and all good from the rails to the battery. Works when portable but it has to be plugged into the charger to recognise it then can be unplugged from the charger and works fine until the console is turned off. I then have to do that process again to use portabley. Thanks for any help.
For the definate answer answered by a reddit user. This is the fuse to be bridged or replaced
Same problem. Did you find a fix?
Nevermind, Found it XD
Any updates about this specific problem? I really want to avoid replacing the whole board for a broken capacitor..
The so called “fuse” is very difficult to bridge with solder or a wire and when I tried it the result was to destroy one end of the fuse making it impossible to bridge. Luckily I found out that one side of the battery(the positive) is connected to one side of the fuse and the other side is connected to a nearby small pad which makes it easier to bridge. I enclose a picture of what I did…hope it helps. This fix is for the right joycon but I guess the left joycon has something similar which an ohmeter can discover….
