Chosen Solution
The disc drive itself works fine, tested in other consoles and moved the circuit board to other disc drives.. the issue is that the circuit board makes it so it doesn’t accept discs. All the connections are snugly fitted so it can’t be that. Is there anything I can do? If I manually insert it, it won’t eject either.
The problem is that there is an ear on each side of that ribbon cable and when it is not removed correctly it will tear off inside the connector. Then when you try to put the ribbon cable back in it catches on that ear and won’t go in all the way. Sometimes you can trim the ribbon cable so it will fit, but sometimes you need to replace that connector and replace the ribbon cable.
I don’t know if this could be why but the clip you push in to release the ribbon cable usually doesn’t actually seen to clip in, I can push the cable in but it will just pull out, but it will also stay in fine
http://i.imgur.com/VeknDGU.png This seems to be the culprit. No matter how much I try the right side if the cable won’t go all the way in. I’ve tried compressed air on the port and a soft brush incase anything was stuck but that hasn’t made a difference. Sorry to ask you again but do you know if there is anything I can do @tronicsfix I’m not too sure though as the eject button still works, all the other connection of the daughter board are snug but I dont know which connection controls the motor Okay, I don’t think it’s that then as I put in a cable with no tabs which fit in fine, yet it still has the same issues.
