Posts

Chosen Solution It that my tablet was on meed need and my knee hit it and just 2 little crack appears and now I can’t move the screen at all plz help. Try to reboot it by holding the power button down till it shuts off . This could take 10 or more seconds once off wait a few minutes then restart it . If the screen responds to touch your in business but if it still doesn’t work then you’ve damaged the digitizer and the screen and digitizer will need to be replaced....

Chosen Solution This started happening yesterday so I turned it off and left it overnight it was working for a little bit but it started happening again with these weird pixels and booting into a white screen Sounds like the GPU board is failing! In its day the AMD GPU was able support the apps people where using. Sadly the Apps matured very fast and eclipsed what this GPU could support....

Chosen Solution Have had this tv for some time i cant find manuals for it anywhere. Not even here. The screen has slowy be darking over the past 2 years. Now its to dim to watch! Any suggestions as to what it could be or a point in the right direction as to a manual or parts schematic ! Thanks!! @undergun it does sound like you are having a backlight issue....

Chosen Solution what size & length are the 6 screws that attach the TV to stand on a westinghouse model # VR5585DFZ. I lost all 6 screws THANKS Hey Jack, you should probably refer to your tv manual. I believe it’s on the top part of page 6 (shows it in the link). -Let me know if this helps. -Please accept this answer if it answers your question. i need the 4 long screws on the bottom of the stand

Chosen Solution Hi, I have a Hotpoint washer/dryer machine, and a shaded pole AC fan motor (see here) in it, which “works” very strange. If I connect it directly to the 230 V power network it runs very slowly, sometimes even stops, then start to spin again, and so on (no any load on the motor of course). But I can turn the motor with my finger easily. I made a little video, where you can see the rotation stops at 00:04, then restart....

Chosen Solution I work in a photo studio and when a Mac dies it goes to the styling room shelf graveyard. Recently I volunteered to clean out all the old electronics…YAY! I will be sending about 10 very old Mac Pros to the recycler. Should I wipe the hard drives with specific software or should I pull them? And if I pull them how do I safely destroy them? Thank you :)...

Chosen Solution my mac won’t read my ipod when it is plugged in. when i plug it into my computer, my ipod shows up with very low battery, and then after that shows the apple start up screen, sounds like it is working (makes a whirring noise). but then kills itself, and starts up with the apple screen again. this loops until i unplug it from my computer, or wall charger....

Chosen Solution Hello All, I have been going nuts the last 24 hrs trying to figure this out. Here’s the deal: Computer shuts down as soon as I pull the power Has a new battery Has new Ram Running 85W MagSafe Adapter Battery indicator lights are all blinking when adapter is connected Have tried doing a SMC reset (preffered way and manual using a terminal prompt) Have tried resetting the PRAM, I know this is not connected to battery issues but tried anyways I’m at a loss....

Chosen Solution I’ve been having this problem for months now. Whenever there is a quiet moment during a movie or video game or something, my TV’s audio (Vizio D series) cuts out, by which I mean that the background noise cuts out abruptly when there is a pause between conversation. Not a significant problem per se, but it’s very annoying. I’ve tried various audio setting combinations but to no avail. 99% of the time, I use my PS4, but it does it through the cable box as well....

Chosen Solution Ok, here’s a weird one: Last week I was using my 2011 15” MBP as normal with no issues on battery power. I was checking email when a family emergency presented itself, so I left the MBP on the kitchen counter. Needless to say, when I returned, the MBP had gone into deep sleep as the battery had died. I plugged in my power adapter and waited until the battery was fully charged....

Chosen Solution Hi, I have a few questions: Why are there two wifi modules and chips on the xbox one x? What is the purpose of each one?Why does the xbox one x transmit wirelessly despite the unit being off, connected via usb and with the side wifi module disconnected? What is the purpose of such transmission?Why does the xbox one x use the ancient, hacked and insecure WEP protocol, and is the unit insecure and easily hackable as a result?...

Chosen Solution Hi guys, thanks for reading my question! I’ve got an iPad Air in a reboot loop. It goes to Apple logo, sometimes flashes red, then restarts. I’ve tried freezing it then charging it, it charged a little, but still went back into this loop. Some background. This iPad wasn’t charging, so I cleaned the charge port. I then noticed that the battery screw wasn’t done up properly. After a half turn the device started pulling a current....

Chosen Solution Hi, I have a Samsung UE40H5303AK television which has a subtle flicker in the backlight. The leds go up and down slightly in brightness and from what I’ve seen the flickering becomes less severe after having the TV powered on for some time (although I’m not sure). I’ve measured all the pins on the PSU when on and off and it seems to be working perfectly and so does the main board....

Chosen Solution My iphone 7 taptic engine stopped working after a few hours after my phone got wet. The LCI is red, I powered off the phone and opened the SIM tray and let it dry overnight, but the taptic engine still doesn’t work. Only if is 100% clean water you can let it dry, anything else will left residual materials that will start making contact between small components inside of your phone....

Chosen Solution my Citroen c8 doesn’t start? With a broken timing belt you will have: bent valves damaged pistons possibly bent con rods Or just a useless timing belt. Do not try cranking the motor over (might lead to all issues mentioned above). Take it to a capable garage! Insert your car’s key into the ignition switch and turn clockwise until you hear sounds from the engine bay. If you have a keyless push button ignition it requires you press on the brake to start....

Chosen Solution Please help me, my 2011 jeep grand Cherokee Laredo shows message” key damaged” and I have to remove the push button to start the car. So what could be the problem? Update (04/20/2019) Even when using the spare key, is showing the same message KEY DAMGED Go to your dealer and have a new key made. Take your title with the VIN number on it.

Chosen Solution As abive and requires a soft reset. Is there a problem withbthe screen? Soft reset as in hold power and home button for 10 seconds? Does it do ghost touch? Stop responding until lock and unlock phone? Usually this means a bad screen. Sometimes I have fixed this by putting a tempered glass screen protector.

Chosen Solution Hey! I have had this phone for almost a year, my ex gave it to me and I’m not sure how long he had it. Anyways, it was working fine but one day I tried to charge it after it had died, but whenever the charger plugs in, it shows a picture of a battery and a little red light appears, it didn’t do that this time. So, I tried to hold down the power button and the screen would say “Samsung Galaxy S5”, well, it did that but then it instantly shut off....

Chosen Solution I bought a Crucial 1TB SSD to replace my original 1TB HDD. Utilizing a USB port, I formatted the drive with APFS, installed Mojave, and restored date/settings from my HDD to the SSD. It boots fine after selecting it to boot in startup disk (system preferences). My question now is: Can I simply replace the HDD with this SDD? Is there anything else special I need to do for it to boot?...

Chosen Solution hey guys! about a month ago, i went to boot my PC. it was booting to a black screen, then after 10 minutes or so, it went to the recovery mode, in which i ran the CMD prompt, and found the registry hive had been completely wiped. I installed windows, which ran for about a week, before it started booting to “Boot Mngr missing” After a drive pull, i found that the system drive was failing....