Chosen Solution Hi I have updated my iPhone 4 to iOS 4.3.3. After doing this I tried to unlock it and while doing this my phone got struck into the restore mode. I have tried all the programs available and to get it back to the normal mode. I do not know what I have done while doing this and now when I connect to iTunes it says the device cannot be restored, the device isn’t eligible for the requested build....
Chosen Solution open a small angle the screen works but keep opening the lid will show many stripes. You are facing a known issue with the new display design. This design uses two ribbon cables from the display to a T-CON board which sits in the main case unlike the older models which had the T-CON within the display lid. The ribbon cables have been a big problem for Apple in this design there are in fact four cables one for the iSight camera and mic, backlight power and the two for the display as you can see in this breakdown....
Chosen Solution All of a sudden the display of my MBP does not work properly anymore. The computer powers up ok, but the display stays dark with a thin white line at the bottom of the display. The white Apple logo is lit. I can connect an external display, like my iMac27, and operate the MBP from its own keyboard and trackpad; all seems to work well except the screen. I have tried PRAM and SMC resets, but without success....
Chosen Solution Hi there, I recently purchased a mac listed as spares/repairs. The mac when shipped had no charger, ssd and a waterdamged battery. All of which I have now replaced. Unfortunately when I powered it on for the first time, I realised the screen is also gone. Looking at replacements online cost anywhere between 400 to as much as a 1000. I only paid 300 for the laptop itself, 550 altogether with replacement parts....
Chosen Solution So I just replaced the screen on a surface pro 4, however the touch screen doesn’t work when i use my fingers. It works fantastic with the pen and with the keyboard, but not when I use my fingers. The cables are seated properly so I don’t know what the issue could be. Did you double check the digitizer board behind the screen to see if the ribbon cables are fully inserted and clipped in?...
Chosen Solution I did a battery replacement and I did something I probably shouldn’t and didn’t need to do, I removed the screen. Before, this phone just had a water damaged (but working) screen and a spicy pillow. Now after power cycling, repositioning the connector, and hard resetting, it still shows this. It’s different every time, but every time it turns on from boot, everything is fine until the apple logo turns greyish....
Chosen Solution How come all my storage say computing with an sd card in my phone and when i try to move apps that ARE compatible with the SD card it says unable to move app, why is this???? its really annoying me cus this phone only has like 4 gigs of space I can use, 8 in device but like 3.5 is taken up by system data. Get a bigger sd card
Chosen Solution When replacing the battery, should I remove the SIM card? Removing the SIM card and/or SIM card tray is not necessary when replacing the battery on an iPhone 4 or 4S. The battery is on the other side of the device from the SIM card, you only need to remove the back panel and disconnect the battery connector before actually replacing the battery. You can find a guide here - iPhone 4S battery replacement guide...
Chosen Solution Full throttle and full forward and it doesn’t have much go anymore? On my craftsman DYS4500 You may want to check the condition of the drive belts . Or if its hydro static drive check the oil level. Hope this helps
Chosen Solution I have a macbook pro which is frustrating me. I spilled a drink on the keyboard awhile back and have issues. I got it back working but with a few keys not working. Everything was fine. I left the laptop alone for 3 months while home and the battery went dead of course. Now, the light on the power plug(green, Amber one) won’t light. Battery will not charge. Only way to power it up is to unplug it and plug it back in and it boots....
Chosen Solution When i try to make are answer a call all kind of different abs cum up and my main phone screen disappears so its hard to even dial other numbers are answer calls You haven’t given us much information but it sounds like you may have a defective screen (ghost touching). You could take a look at this guide to see if you want to try and replace it yourself....
Chosen Solution Hello! I have two similar devices, both with the same issue — a Sonos Connect and a Sonos ZP90.Neither device will power on—when plugged in, the light on the device doesn’t come on, it won’t connect to the network and won’t operate (at least, so it appears). It seems like the device itself in both cases isn’t receiving power—I’ve tried multiple outlets and power cables to power the devices, but with no luck (so it’s the device in both cases....
Chosen Solution This is an active subwoofer that just stopped working recently; I think the “tap” test on the post of the input RCA plug indicates that it is the subwoofer, not the amplifier, that is dead. Checked the fuse, it appears to be fine. So, after searching online forums, I began to suspect the STK404-130S IC shown in the pictures. Counting from the left, I read that pins 12 and 13 (the last 2 on the right) should have 0 v when powered (pin 5 is ground)....
Chosen Solution Hi Recently I could not boot my macbook as the blinking question mark folder appeared. After some troubleshooting and tinkering, I found that there was an issue with my HDD cable. So, I got my hdd cable replaced and now the system is able to boot with the ssd. However, now the ssd has become very2 slow. Every few minutes, the colourful beachball mouse pointer comes up and the application state becomes “Application is not responding”....
Chosen Solution I have a 27" i7 iMac that I bought close to two months ago, and I would like to replace the internal HDD with an SSD, and I have a 2.5" to 3.5" form factor converter. The only thing I have noticed is that there is nowhere on the SSD to plug in the Thermal Sensor Connector. Do I just ignore it? Can I? This is the SSD that I ordered: http://www....
Chosen Solution I bought the second HD kit just after purchasing the Mac in 2011 and installed a 1TB second drive. Ended up removing that drive and the stock drive as well and installing an 80GB SDD that worked perfectly until I ran out of space due to the data files for a massive iTunes library stored on a 4TB external drive. I installed a second 80GB SSD as a user drive to solve the space problem and used the drive utility to combine the original 80GB back into one partition....
Chosen Solution On startup screen freezes on grey with centre circle with diagonal line. I have tried starting holding various keys as suggested on internet sites - control, option, P and R; C; etc. nothing seems to work. The computer has been quite hot lately. Prob a 2010/2011 model. The power transformer also getting quite hot. Perhaps time for replacement of the lot? I had this issue with my MBP and it was because the GPU was starting to fail....
Chosen Solution Hi everyone, Hope I can get some help. Family member has iPhone 7 with cracked screen. Got all the parts I need. I bought an OEM blank screen and would move all components over including the home button. Start to remove the iPhone 7 screen. As we know these are sealed up well. Used a hairdryer to heat up the glue to help speed up the process and used a pry too to get under the screen and got it open after a while....
Chosen Solution I have tried cleaning the lens but my camera still takes blury pics. How can I fix this? If you have tried cleaning the lens of the camera, it is likely that the clear plastic cover of the camera lens is scratched or damaged. This can be confirmed by going to the camera and seeing if the display is blurry before taking an actual image. In order to fix this issue, you will need to replace the plastic camera lens cover....
Chosen Solution Our daughter shoved a random charger into her brothers speaker and broke the port. Can this be fixed? @sharpie75 and @mharrisonline take a look at this guide. Step 6 shows the port soldered onto the board. So it would not be easy. You could try and purchase a broken Bose SoundLink Color and harvest the port from it. Or you could possibly pigtail a separate charging port to it....
