Chosen Solution If I hold my reball stencil up to the light it looks like some of the holes are full of solder paste but I can’t get it to come out. I would have thought it would have came out on the chip. I forgot to mention it is for the iPhone 7 audio ic. I would put flux on it and heat it in and melt the paste clean it with a brush and finally alcohol....
Chosen Solution I have a MacBook Air 13” 2011, EMC 2469 that has issues with high fan noise and laggy performance on boot. I’ve taken the logic board out and found corrosion on one of the capacitors (C9331 according to the board schematic I have). When trying to scrape it off, the capacitor literally just came away, so I think I found the culprit! Being a newbie to board repair, but having nothing to lose because the MacBook cost me nothing - where can I get a replacement capacitor?...
Chosen Solution I recently upgraded my monitor that I use with my xbox but it doesn’t have any speakers, if I was to purchase speakers that use a 3.5mm cable, would I be able to use them if I plug them into the controller? Or does the xbox need to recognise it as a headset to work? I recommend a HDMI audio spliterI’ve tried using speakers with the 3.5 audio port, It didn’t really work....
Chosen Solution Hiya, I’ve got a customers’ iPhone here that’s give my me a bit of a headache. The customer came with a damaged charging port and a draining battery. The phone being now old, I didn’t questionned his draining issue before hand. The customer is on his 3rd visit to our store, initially replaced charging port flex and battery, 2nd time I replaced the battery again assuming it could be a faulty battery (the phone was hanging on Apple logo then switch off)....
Chosen Solution Hi there! If i upgrade my iMac from i3 processor to the i7 one (870 socket 1156) i read somewhere thay this could hurt my powersupply or graphics card, is that the case? Or can i just go ahead? Thanks! As long as your iMac has the 305W PSU, it should work. It’s the same board between the i3 and i7 models so there should not be an EFI limitation....
Chosen Solution Has been running reliably since @dan helped me last year with thermal paste issues. Suddenly the system will hang partially through a status bar or if it goes to user menu, it will let you log in but it will either hang within a few minutes or begin a restart cycle. Tried to go into safe mode and it hangs there also. Tried recovery mode, started disk utility to check ssd and on pass 3 of 7, it froze!...
Chosen Solution Hey guys, I was at my parent’s yesterday and they said their computer wasn’t working anymore, so i took a look at it but i couldn’t figure it out so i hope you guys can. When I try to start up the computer the power LED will only flash on and will go out in less than half a second. Furthermore after it has flashed the LED it will not do that again unless i remove the power cable and plug it back in....
Chosen Solution The handle to my Roomba broke and I need to replace it. How do I put a new one in? The handle replacement itself is a simple task since the handle snaps on and off(no screws required). However, accessing the handle is a different task entirely. The roomba will need to be turned upside down, and partially disassembled to reach the handle on the face of the roomba. A thorough repair guide is being created at the moment, addition information that may helpful can be found on the troubleshooting page....
Chosen Solution The cowheel is always functioning even though I’m not touching it. The sound is always wavy, kinda off tune, and when I am on sync function with the percussion and the bass, for example; My right hand is on C, and my left hand should be on D. When it is on piano mode, it is one note higher. Please teach me how to reprogram it, or how to reset it back to factory settings....
Chosen Solution For a BMW 740iL, BMW require you to use a special tool to adjust the tension on the timing chain for a M62 series 740iL V-8 5.75liter engine dated 08-1998? Looks to me that all you need is 19mm deep socket. Check out what the expert at http://forums.bimmerforums.com/forum/sho… show you and see if that is the information you need. Good Luck….
Chosen Solution On tuesday, I had my screen replaced with a new proximity sensor as well, since the original one was lost. However, my phone freezes and reboots. I’ve tried disconnecting the battery, disconnecting the screen, and putting the phone in DFU mode, but none of that worked. I do not have the shielding screwed on, so no damage done there. Would I need to buy a new proximity sensor, or an entirely new screen with the sensor pre-installed?...
Chosen Solution Hi, Model: iMac “Core i5” 2.7 27-Inch (Mid-2011) I replaced the i5 CPU with an i7 2600. But on boot I got a blinking single LED on LED1. Reading up that normally means insufficient power. The main fan would spin cycle up and down. I put the i5 back in and it boots fine. Things I’m not sure about: I’m assuming the CPU is good, but can’t be 100% sureI didn’t put the RAM back in when I tested the i7, but normally you’d get a long tone....
Chosen Solution Is there a way to replace the main LCD flop if its broken in the middle? Nathan not sure what you refer to as the LCD flop, but I know that the disassembly directions are posted right here [ http://www.globaldirectparts.com/Samsung…|and parts are here] Hope this helps…..good luck
Chosen Solution i have iphone5 and the right side is not working but the left side is there are 5 lines going down the screen but there nothing wrong with the screen it like inside the iphone is not working the right side is it posible for it to be fix if can how much would it be and do u think they can fix it at bestbuy? please answer quick...
Chosen Solution Hi there, Firstly, the phone we have was not listed. My son has a samsung A40 (UK) after only having it for a few months the phone stopped charging. We bought a new cable and checked socket etc but still nothing. We contacted the provider who told us to take it to car phone warehouse. They said that it was a faulty charging port and that it wasn’t covered under warranty....
Chosen Solution My Samsung UA46EH6030RXXA Screen has a crack in it. Audio still available tho. How much will it cost to repair @LindenLategan Hi, A replacement panel, (if you can find one that is) can cost nearly as much as a new TV. An option to consider is to sell your TV as faulty screen, good for parts to try and recoup some of the cost towards a new TV. If you wish to try and source a new panel, remove the back cover from the TV and locate the panel model number which should be on the back of the panel somewhere....
Chosen Solution I have a HP laptop. When the cover is half opened, the screen stays ok. When I open it so I actually work with it, it flickers, turns complete white or black. When pressing at the bottom of the screen, just above the logo, or when pressing the bezel at the bottom the screen is OK. What could be the issue, how can ifixit? Could it be an grounding issue?...
Chosen Solution When turning on the phone will not boot and the display keeps turning on and back off. Here is a video of the problem: https://youtu.be/OW-MsQnLGEM It seems to be bootlooping. Has the screen or any other part been replaced? Check your battery is charged up and good. There are a few things that cause Boot Looping, but one of the first things to check is a strong battery or use a DCPS to power it up ....
Chosen Solution So, I’ve had pretty much the same problem. My laptop was working perfectly fine, I shut it down one day, and then i couldn’t turn it back on. Here is what has worked for me. I’ve tried keeping it charging for multiple days and that doesn’t help at all, but if i leave it without charging and come back to it like a week later, it turns on perfectly fine like nothing has happened....
Chosen Solution Hi, I noticed that the sound volume of any recorded video in my iPhone 6s starts low and then increases/ decreases with no obvious reason. The sound result is like switching microphones front/rear, however I am not an expert and this is just a wild guess to describe how it feels like. When I play the video in my computer, the sound issue is still there, so it should be a microphone hardware or software issue?...
